Search results

i'm back on the GN that die, it is the same old story, no start. Measuring voltage at B5, i'm getting 2.5 volts with switch on and will bounce around a little when cranking. New crank sensor installed and set up. Also new plug at crank sensor and wiring. NEW coil and ECM and ignition module...

Car at idle is running 98 BLM's ( car has warmed up ) my MAF is 6. TBS at .40 and IAC is 21, 02 reading is high at 835 WOT. Car is running rich. I have used Thrasher 93 and armstrong 93 chip, both had low BLM nunbers. no malfunction codes. Did not record BLM numbers at WOT. What can i do...

Does any one know who does new leather on the TR steering wheel? Any one a happy customer after using the new steering wheel. Cost ??? Thanks

What type of filter should i be using on a alcohol set up ??? Need brand and part number. Also is Shurflo the best pump to use on alcohol systems ?? Thanks

smc kit works great, no problem except, once in a while the rca terminal will work loose and NO spray. Any one found a way to make the connection tight and not work loose ?? Maybe Steve can have a up grade way of connecting the wire set up in the future. Thanks for any ideas that work

Just installed Casper's P/N 102049 ( pass-thru sender ) and P/N 102046 VSS converter module, I have check and rechecked the wiring to the instructions and according to my scan master, i still not reading and MPH at the ECM. I have a Auto-Meter P/N 2694 mechanical speedo, that still works. I do...

Just put in a scanmaster, most of the reading are in the good range. But the IAC is reading 0 in park and at operating temperature. The IAC motor is new w/ about a 1000 miles. I try to raise the IAC number by turning the throttle stop screw counter clock wise ( closing the throttle blade ) but...

Has any one used the radiator coolant tank as a holding tank for a gravity feed into the SMC tank ?? I have mounted steve's tank below the coolant tank and would like to use the coolant tank as a point to refill the system. What type of hose should i be using from the coolant tank to the bottle...

The car has not been running for a while. Try to start up the car and NO starter. I have check my battery and it has a full charge. Went i turn the key to start, nothing happens. Question if the orange ECM from + battery wire was broken, would this stop the starter from starting ?? Is the...

Just install the SMC dual nozzel set up, I'm still trying to fine tune the set-up and used one bottle of 100% alk in two days. I would think it would last alittle longer. I'm trying the mix of water to alk. It seems that 50% of each is the way to go. Thanks for any input here

I'm getting the rear brake lights working some time, the third light is working all of the time. The brake switch has two plugs. one has three wires: orange Hot, white, and blue/black tracer. the blue/black goes to the rear brake lights ( i think ) the switch is working, i'm getting a test light...

Before I try to remove the speedometer cable, i need to know how is it attached inside under the dash. I have already taken it off the gauge and unscrewed the cable ( two pcs. cable ). Is the cable attached at the fire wall or inside under the dash?? Have not done this before, so would like a...

Will P245/60R15 fit on front with-out rubbing on the fender or frame ?? The car is a 86 G/N with stock chrome wheels. I have P215/60R15 on now. Planning on using P275/60R15 on the rear. I do have new springs and air bags on the rear. Thanks for the info:) :)

Before i start to look for the fuel tank sender wire, what color should it be?? Does the wire run inside the car or along the frame?? Is it part of the pump wiring?? I'm wiring a new gauge ( Auto meter ) and need the correct wire. Any good point under the dash were i can look for it...

Car has been running really sluggish, code came up as 43 !!! I changed out the knock sensor and esc module, still code 43 !!! check the ground at the esc module seems ok. Would one bad injecter not working give me the same code? I do have one injecter #4 not working, harness measure ok, but can...

just did some reading and came across something that has me concern. I have been running the car with the following wiring to the coil pack. front : left to right 5-6-4 rear: left to right 1-3-2 123 driver side 654 passenger's side front to rear this is the lay out in Kirban's...

What is the voltage range at the fuel injector ?? I have a problem of running only on 5 cylinders, ran it down to #4 injector, no reading with volt meter or test light. new wire harness from casper, car has been running really strong, then one day, running like S$&T, check every thing, came...

Has any one had any dealings with Keith at Newton motor sports.He is located in Tuscaloosa AL. He has some good numbers on Turbos and claims to give a year warranty. Thanks:)

Does any one have or know were you can get a diagram of all of the vacuum lines ??? :) Thanks

Has any one ran into a code 43 problem ?? check wiring and plugs at ECM and ESC module. Base on the knock gage, i will get into the last red at WOT and start to get green lights at 7 lbs of boost. Can the Knock sensor be bad ?? Also car is running really rough at idle, gets alittle better...