Search results

How much for the rear taillight harness so long as it's uncut.

See post about GNX for sale and photo of engine compartment shows silver:smile:

it's a gasket that fits over the interior door handle release then you put the interior panel on. It keeps wind drafts from blowing thru the door handle opening inside.:)

Try removing the vanity panel under the dash and adjust it by loosening the bolts there.:)

Take a pencil eraser and clean the contacts. I had what was thought to be a dead antenna and this made it come back to life. A little bit of corrosion and it won't work right. If this doesn't work get the test leads to check for power at the connection.:)

Metric;)

Somebody give the man some M&M's;)

I've found brush and roller cleaner found in the paint dept at Home Depot worked easy with a Q-tip:)

Well I just had to replace my SERENDIPITY BELT and I'm not happy about it!!!;)

For a quick fix you can use license plate screws with some locktite.:cool:

1991. I called on an ad . A guy up near Peddler's Village Bucks county Pa. was selling his for sticker $29,900.00 I went up and test drove it. SWEET!! I remember the exhaust rattled againt the under carriage. He was a builder and apparently was unloading his toys collected from the mid to late...

You could have gotten very early in the 87 model run a WO4 turbo regal - all black with the grey interior with the LC2 turbo engine- no rear spoiler with the chrome bumpers and chrome outline of the side marker lights by the headlights - but not on the GN. This was replaced with the WE4 all...

I have used a battery tender in three cars. Two are garaged and under cover one is covered in the driveway and no problems at all. Outside has been done this way for six years and inside for six and Ten years. The battery tender has a chip in it so it automatically comes on only as needed...

He moved up north of the Easton pa. area. Yes, he retired from the car repair racket. Contact Jim (Sr or Jr.) At Warminster auto repair for more info. Either is quite versed on Turbo Gn repairs as they worked with Dave.:cool:

where are you located?

And that is NOT a factory alligator clip on the adj wastegate:eek:

Just get some 60 lb test fishing line in the sporting goods section.Take a section of it and pull thru between the molding and the sheetmetal - if you are lucky you can get under the adhesive and it will come off clean. Use 3m adhesive remover to clean up what's left on the car. You won't be...

Take it to the Buick dealerand they will do it at no cost since it was a recall. Why use your good switch - keep it as a spare:)

If it came from the top left side it would be for the Light sensor that would have been in the center of the speaker panel on the top of the dash if your car had the twilght sentinel feature which automatically turned in the headlights at dusk. If your car came with the factory security system...

Sent you a PM:)