Search results

Did anybody watch this show??? I had it down to Toby and Lukas. I'd buy the cd with either one leading the band. I don't care for Tommy Lee or Dave Navarro. Jason seemed ok, and Gilby seemed like a down to earth nice guy. I checked the RockStar websites messageboard and they are just tearing...

One more round for the Italian Stallion. The Greatest Underdog Story of All Time. Yeah Baby!! Greatest character ever in my opinion. trailer:http://movies.yahoo.com/feature/rockybalboa.html;_ylt=Auj84yFPxZHa2aeBGpmUE.VfVXcA

Any other parts recommened to buy when installing a new torque converter? I see Cotton recommends the Hardened Intermediate Drum for trans pushing over 350hp, and the Hardened Stator Support for all new torque convertor installs.

GT6131 with 3000 orange strip or GT6152 with 3000 orange stripe Which setup is better suited for street use?

Did a search and couldn't find anything. Two questions. 1.Cups or no cups with kirbans 100lb springs? 2. Whats the procedure when tightening up the rocker arms. I recall my father talking about zero lash with his ford engines. He would run the car and go from rocker to rocker and...

Got this in an e-mail. Those without a sense of humor don't take it. Enjoy. http://www.dr-joe.net/quiz.html

I installed a BOV on the original PTE up-pipe that came with the intercooler, and need a back up for no BOV. I just bought two new stock 3" up-pipes and they just don't fit, too short. Can pay through paypal.

My brother (16) just picked up a 1989 GTA. An absolute beauty, or "cherry" as they say. Unfortunately the intake manifold gasket went on us right as we got it home. Only had it two days. We are inthe process of fixing it, but I also want to check a few things and get this puppy running great...

Should BLM's ever drop into the 90's, even for just a second?? The only time I've ever checked my BLM's was at idle, and they've always been and still are. After a BOV install and the car bogging down on me when coming to and leaving a stop, I checked my numbers and my blm's were dropping...

Getting rid of my BOV(piece of crap), and need a new PTE SS intercooler up-pipe. I can either get a replacement PTE, if possible. Or get an aftermarket 3". But I noticed that the stock 2.5" is about 1.5"(length) shorter than the PTE, is that the same for the 3" aftermarket up-pipes?

Sweet!!, got me the sand etched one on the way! http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&category=50446&item=7985785948

BUICK GRAND NATIONAL ATR TIMING DOCTOR CONTROL Injector Timing Tuning Device http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=7986037660&category=33553&rd=1

Hemmings Muscle Machines Issue#23 August 05 It's My Turn In the Backfire section of issue #21, reader Rod Heubach wrote to comment on some advice about a throttle position sensor setting specification I supplied to a reader. Mr Heubach is under the impression that on a Buick-produced...

Car bogs down when coming to a stop, and while accelerating out of a stop. Looking at my numbers my BLM's are dropping into the 90's during the bog down period. I changed out my stock chip for my extender, made some adjustments to the translator, lowered my fuel pressure a million times as low...

Post your GNX settings? What are the little tweaks you did to make the car perform better? Las Vegas Drag strip time? Road Course performance?

Anyone use this headliner setup rather than re-doing it yourself with just new fabric? http://www.1aauto.com/1A/headliners/Buick/GrandNational/1AIHL00287/131781[/URL]

Anyone know anything about guitar speaker cabinets? I am trying to wire my bro's cab so it will see 4 ohms in mono. 4x12 with 16ohm speakers. The amp continues to get hot and shut down. Right now the speakers are seperated into pairs, both with their positives and negatives connected...

Route 40/Pulaski Highway, New Castle Delaware. We stopped and looked at it about 4:00am last night while working. I spotted it out of the corner of my eye. Very nice condition, 94k, stock turbo, 3" THDP, 206/206 cam, scanmaster, and my Dad said there was something else on the dash, I took a...

Car started but ran like crap and service engine soon light was flickering, scanmaster wasn't working. I was able to get the car out of the garage and let it run for a while. I jiggled the aldl wires and was finally able to get the scanmaster to work and the SES light to go out while running...

Does a BOV need to be re-routed to go back into the intake?? I read that dumping the air into the atmosphere is not good for our cars; "putting a blow off valve on one of these cars is more complicated than just welding it into the up pipe or the intercooler and putting a vacuum line on it...