Search results

I'm removing the drivers seat of an 86 Limited. It is a power seat that is all the way forward with the motors not working. I can't seem to get to the front bolts. Is there any way to move the seat back manually?

I have been posting on this and on the other board for quite some time now. I have also informed you all about MPE Fabrications (Keith Mease) ripping me off. I found out that I am not the only one and would like to bring this guy to some kind of justice. I am going to write a letter to the...

I know that this should probibly be posted in another forum, but I want maximum viewing. I have been working with New Jersey's department of consumer affairs for the past couple of months. Long story short, if everybody that have not gotten their parts complain, an investigation will be opened...

Can anybody help we with where to find an upper plenum gasket? I'm having a hard time locating them online. Thanks

What happened to Kirban Performance? I have been unable to reach their web page. Did they go under like ATR?

With the new engine and wiring harness in, I still cannot get the engine to run without having my foot on the gas. I have checked all the vac lines and have found no leaks. The vac lines are new by the way. I am at my total wits end. Please somebody help, the wife wants the car fixed and out...

I have gotten a chip for the ECM that will run the 60# injectors. I also replaced the ECM. Now I can start the car, but in order to do that, I have to have my foot on the gas. The car threw a code 34 and I will be checking the voltage tonight when I get home from work. Could there be...

I am getting out of the Hot Air ring. I have switched my power train to the 86/87. I have tons of parts for the Hot Airs and want to get rid of them. I have sensors, throttle bodies, intakes, and even blocks. One block is a Hot Air and the other is from an 85 rear G-Body car, it will handle...

I got the engine started!! Thanks to all Now the engine runs very very rough and there is a ton of black and white smoke. I think that it is running very rich, but am unsure how to lean it out. I also did a diagnostic and I get the 12 code, then the engine light goes out and the fuel relay...

OK, I looked at the ground wires and reattached them to ensure better grounding. Now when I turn it over, it sounds like it wants to catch but dies with a backfire. Could my cam sensor be 180 degrees out?

I have finished converting my Hot Air to the IC setup. I have everything hooked up right (as far as I can tell), and it will turn over but won't start. I hear the fuel pump running and getting up to pressure. I'm not sure about spark. I shorted out the A and B terminal to do a diagnostics...

Can somebody please steer me to where I can buy a set of power steering lines? Napa and Advance only carry the pressure line. I am looking for the one that connects from the steering gear to the reservoir. Please help!

Does anybody know where I can get the PWR steering fitting that connects to the pressure hose? The part number is 7849856, its basically the hose that wraps around the power steering pump and connects to the pressure hose. I appreciate all help.

I need some help from the group. A few months back I talked to Keith from MPE Racing Fabrications about purchasing his stock location intercooler and high flow cat. He said that it would take a couple of months to get the items to me. My engine was still being rebuilt so I was in no hurry...

My tubo is missing the brass fitting that the vacume hose from the wastgate selenoid attaches to. Can somebody clue me in as to where I can get another one? Thanks

I am in the middle of a Hot Air conversion to IC. In the area of the fan, I have noticed that the fan from a Fiero will fit perfectly with the exception of the wiring being different. Has anybody done this conversion? If so, how did you wire this up? I appreciate all help

:confused: I just got my transmission rebuilt and did an engine/tranny install all at once. In hooking up the linkage that goes to the steering colum I noticed that it will only shift into three places. I don't really feel like dropping the tranny to get it fixed, I am just wondering if...

Ok, since ATR closed its doors, I am left without an exhaust. Does anybody know where I can get a GOOD exhaust system and cat? Thanks in advance.

I am selling off my Hot Air parts. All prices are not set in stone and I will entertain all offers 3 Hot Air Intakes w/ fuel rail and fuel wiring harness; One is blasted clean and looks really nice. One was installed on my Hot Air and has been internally cleaned. The third is in decent...

I was trying to call ATR to place an order but their phone number came up disconnected. Their web site is also unreachable. Has ATR gone under? Now where can I get my exhaust and liquid intercooler? Any thoughts or suggestions?