Search results

My brakes have worked fine until a couple of days ago. The brake light on the dash came on a couple of times, so I looked at it a little closer and noticed the powermaster motor is running all the time. I pulled the plug on top by the accumulator and the motor quit running. I don't want to...

My car's power antenna is dead--reeeally dead! Mast is gone, motor is shot. I need a complete replacement and I'd like to know what will interchange from other cars or what options are out there?

I need to replace some of my speakers and I'd like to know if the 4 and 6 speaker systems use the same dash and rear speakers.

I need to ship a pair of heads (42 lbs each). I checked the UPS site and it looks like they'll cost about $60+. Is there a cheaper way?

My car starts and runs fine for a couple of minutes. When it changes from open/close loop, it runs terrible and dies. No codes, readings are normal until it dies. What circuits are activated and might cause this to happen (O2 sensor or ?)? Most parts are relatively fresh on the car.

I'm on my 5th ECM/computer in less than 1500miles. I'm not sure why I keep killing them. I've replaced almost every electrical component/sensor and rebuilt the engine. I checked all grounds to the engine, etc and haven't found any problem. Here's what the car typically does when it dies...

I purchased the am/fm/cd player, amp, and speakers from a '99-01 Camaro and need some info on the wiring. If anyone has done this, please let me know the details.

My Monsoon radio came out of a '99 Z-28. It has the 4-plugs grouped together with a total of 20 pins. It also has another plug with 9 pins. Does anyone know what it is or if I'll need it?

Anyone know what adaptor plugs I'll need to install a Monsoon radio, amp, antenna and speakers into my 87 GN w/Concert II? I looked at the Metra website, but there seems to be a lot of part numbers for similar items. The numbers I'm looking at are 71-1858 (plugs into the radio), 70-1677-1...

I bought a nice bumper at the junk yard because it came with the aluminum reinforcement brace in the back. Unfortunately, the bumper is chrome. If I want to paint it to match my GN, should I sandblast it, sand it, or have it stripped at a chrome shop? I think the chrome shop would be the best...

Are all cal packs the same if they're in a 1227148 ECM? What exactly does the cal pack do?

I just got my engine back in the car and running again. The rpms seem to be double on the factory tach. I don't really use the stock tach, but I'm curious why it reads so high.

My 87 GN has the concert sound system and the radio is shot. I'd like some recommendations on replacement components. I know it's a vague question, but can anyone give me a list of components (adaptors,speakers,stereo), rough prices and where to buy them? I'm not looking for anything fancy...

Does anyone meet/hangout anywhere around S.A.?

I'm thinking about installing a 2004r in my '40 Ford behind an LT1. Price seems cheap. Do you think this would be safe? http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=1844622067

Before I re-install my engine, should I port the plenum or intake? If so, do I just gasket-match the openings? I'm installing a Powerplate too.

I bought new motor mounts and noticed they hit the freeze plug boss as you tighten them up. It kinda tweaks the mounts as you tighten them. I don't have the old ones to compare. Is this normal or am I missing something?

I'm trying to figure out which sensors go in the front of the intake. I have a sensor with a flat/spade connector, one with a round connector and another empty hole. Can anyone tell me which one goes where and if there are 3 sensors?

I'm installing my engine and would like to know what to install with the engine vs after it's in the car. For example--a/c, alt, turbo, headers, etc.

I need to install the P/S pump pulley and need to know how to get it back on the shaft. Do you just use a bolt and impact gun?