Getting ready to install a second nozzle in my up-pipe. Its a stock style 3" up-pipe and the first nozzle is located just past the bend about 3.5-4" from the TB.
Should I install the 2nd nozzle directly across 180 degress from the 1st, or make it a half inch or so off-set but 180 degrees from the first?
Was thinking if they are directly across from each other then the spray will collide in the center and be concentrated there which may not be so good...under boost it's hard to tell what would happen.
Should I install the 2nd nozzle directly across 180 degress from the 1st, or make it a half inch or so off-set but 180 degrees from the first?
Was thinking if they are directly across from each other then the spray will collide in the center and be concentrated there which may not be so good...under boost it's hard to tell what would happen.