Search results

Thanks man!

^^ is that on a stock width wheel? Thanks

I am runnig 275/60 on 8" rim on the rear(tall), looking for a front tire size to give it the right stance Right now the tires I have on there makes it look lowered in the front. I think 215/60"s

Zamboni's- Gibsonton Dr Coastal Dyno- Causeway Blvd between 301 & 78th st

Yeah, excessive wear on rear tires!!:D

Info on meet would be nice...:biggrin: Locaton for some of us that dont know about it, Thanks

I run f-body fans, car runs cool

I done Dutt neck and 3.5 maf conversion at same time. I noticed a big difference. No times yet but definately feel in seat of pants. HTH

After you make changes have you been unplugging orange wire by the battery to reset ecm?

Thanks for the info pmed

I cant believe all the HATERS!!! If you dont like the imported products the dont buy them. I seen a set my buddy bought, shipped to him in a few days and was of good quality and craftsmanship. Anybody that has done fabrication and welding KNOWS that each cut and weld is individual, American made...

who are you guys using in the Tampa are to do macine work? Thanks

dont know how to paste it over here but its bmr fabrications not the bmr suspension that comes up first if you google it

Blackbandit asked why he wanted a 700. I gave up on putting money in 200's. 1st is lower, I run 28" tall tires helps some, plus there is hardly any lag to speak of. Internal a significantly larger than the 200's. Will it live? Time will tell, was a lot cheaper to try than the 200's that ARE...

I like my 700 in my GN!! Thought I would give this a try before going to a 400. Drive shaft is the same BTW. I forgot which plate I used to install mine

Did you find the problem? Post update GL

Has the radio been out? Original or aftermarket?

Didnt see anything on replacement of sensor. Stock gauge or aftermarket gauge. I have had an Autometer electeric gauge do this. Drove me crazy till I figured it out!! I finally pinpointed the gauge when it read HOT before it had time to get there This doesnt explain loss of water though GL

If you have the heads off do both at the same time. Why wouldnt you?

I just installed BMR Fab. upper/lowers on my car. Quality pieces!!!