Recent content by 89ICBM

I am interested in the harness. Email me back at at '89icbm@att.net' and I will make you a good offfer, if this is the harnes that goes thru the fire wall to the emc. Frank PS The forum has changed a bit so I didn't know how to pm you.

Hi phillyturbosix, A relacement part (made years later) does not make the car original! I can say this because there is very few parts on my TTA that is original but, I never planed to sell it anyway. Just a point of view.

Hey Pardner! Lawrence is here in the Houston area, I know him his wife and his son If you had work done buy Conley it was by done someone else in the area.

Hi Kma697, Just from experience, have a proffesionl do this. The expence is minimal and it will be right. If you don't do this day after day many times a day, well! I think you can undertand.

Hi iantatta, Well, I decided to respond. If you are actually running 160 lbs per cylinder that means you are running at a 10.3 compression ratio. You are correct in the measurment aspect. You do need a dial indicator to mesure top dead center and bottom dead center to calculate center line...

Hi I Wantatta, I'm not saying this to start a problem but I think you should know. The compresion ratio is determind by the cam. You can retard or advance the compresssion by moving the timing chain on the cam. Has your motor been worked on? A lot of shops build a 350, don't work. No offence...

really!

Hi tta983, Your cylinder compression is what the compression ratio is. The TTA comp/ratio is 8 to 1, this means that there's 8 times compression over atmospheric pressure which is 14.7 psi. This means that if you are at 152 psi per cylinder presssure you have a different piston in the motor...

OK! I give up! Could someone please explain what is being talked about here? I did check my original cat and there is a flange there, the rest of the exaust has long since been gone.

Honestly, I don't think any body actually uses the originals except for show, they're just to damned expensive and very hard to get. I don't think you can find a set for under $250. I use MSD's from Summit. You cut them to length and they work just fine. HA! I had a girl friend that thru my...

Hi Dave, Sorry but I'm not clear on what you need. As I recall, the cat is hard piped in and out, even with an after market 3" exhaust. Please clarify.

You Sir, are are very COOL dude and you have this Irish Texans respect!

SO! You want to argue! This is my assistant! When this person speaks, I listen. Unless your gay, I think you will listen also, and agree. :eek::D

Hi HasBeen, TurboTweak absolutely! I would say if the chip in the car isn't stock and you have and all stock motor, including injectors, then the chip is either a Thrasher or a Pit Bull. Neither of these will help like a Turbo Tweak prom. You do need to know what the iinjctors are. Just have...