Buickforlife
Tyler Northcutt
- Joined
- Aug 18, 2008
I dyno tested my car today. Mods are 60lb injectors with Turbo Tweak chip, alky injection with a progressive controller, walbro fuel pump, adjustable FP regulator, CAI, TE44 turbo, I was running about 22psi of boost. Everything else is stock.
Max Horsepower: 253 @4000 rpm
Max Torque: 341 @ ~3600 rpm
This was at 3520 ft. above sea level
It became quite obvious to me that my stock valve springs are not doing too good. I already ordered some replacement valve springs. It didn't want to rev past 4500 rpm, and it wasn't quick to get there either.
Do these #'s seem ok to yall? I for one was very happy that my little v6 was putting close to 300 at the crank.
Any ideas for mods now? besides the valve springs. I was thinking the 3" external gated downpipe, and a FMIC next.
Max Horsepower: 253 @4000 rpm
Max Torque: 341 @ ~3600 rpm
This was at 3520 ft. above sea level
It became quite obvious to me that my stock valve springs are not doing too good. I already ordered some replacement valve springs. It didn't want to rev past 4500 rpm, and it wasn't quick to get there either.
Do these #'s seem ok to yall? I for one was very happy that my little v6 was putting close to 300 at the crank.
Any ideas for mods now? besides the valve springs. I was thinking the 3" external gated downpipe, and a FMIC next.