northerngn
Master Monkeywrench
- Joined
- Oct 8, 2006
Ok, so i installed the weak springs on the head and used and adj push-rod.
id set rocker to 0 lash then 1/2 turn on adjuster and kept changing push-rod length until roller tip left a mark perfectly center on the top if the valve stem.
just for ****s i compared it to a stock push-rod i had laying around and guess what...its the same length...so i install to stock push-rods and measure on both valves...see pic...does this seem right? am i just lucky?...i thought after building an engine the length would be drastically different from stock
-build uses champ heads w/studs rjc bulletproof h-gasks,comp cam hyd roller,com cam hyd roller lifters,and chev style scorpion rockers with a 1.55 ratio
-dan
id set rocker to 0 lash then 1/2 turn on adjuster and kept changing push-rod length until roller tip left a mark perfectly center on the top if the valve stem.
just for ****s i compared it to a stock push-rod i had laying around and guess what...its the same length...so i install to stock push-rods and measure on both valves...see pic...does this seem right? am i just lucky?...i thought after building an engine the length would be drastically different from stock
-build uses champ heads w/studs rjc bulletproof h-gasks,comp cam hyd roller,com cam hyd roller lifters,and chev style scorpion rockers with a 1.55 ratio
-dan