Last month I got in a older model Translator and reman LT1 maf, I just got around to doing it now and -unless I'm not figuring this right (which may be the case as I have 10 projects on the go and I'm tired), one connector doesn't fit- it does say in the little booklet that you may need a adapter...nice to find that out NOW. Where do I get this thing, the male plug on the Translator connector is smaller.
So do I got this right: you put in the new MAF and then you take the old connector that would've gone to the MAF and plug it into the Translator and then take the other connector from the Translator (there's only 2) and that plug into the MAF?, basically Translator just fits into the chain?.
Also when I received the rebuilt LT1 MAF I called the seller and asked why it was plastic and not metal like in the picture, he said some were plastic and some metal but they are to LT1 spec and it just depends what the supplier sends them. It looks identical to the old one, is this usually the case?. In the pic the new one is on the right with the small connector from the Translator close to the larger MAF female port.
So do I got this right: you put in the new MAF and then you take the old connector that would've gone to the MAF and plug it into the Translator and then take the other connector from the Translator (there's only 2) and that plug into the MAF?, basically Translator just fits into the chain?.
Also when I received the rebuilt LT1 MAF I called the seller and asked why it was plastic and not metal like in the picture, he said some were plastic and some metal but they are to LT1 spec and it just depends what the supplier sends them. It looks identical to the old one, is this usually the case?. In the pic the new one is on the right with the small connector from the Translator close to the larger MAF female port.