Chance Parker
New Member
- Joined
- Jan 19, 2015
I have a short block 109 that I am considering selling. It came with the car I purchased. From the paperwork I have the machine work was done by venciennces machine shop in Hobart/Hammond Indiana. block was bored .030 over and had all 4 billet caps installed/bored and honed to block. It has a eagle 4340 crank, eagle 4340 h beams rods and a set of J&E pistons with file fit rings. Rotating assembly was balanced to 36% by same machine shop as stated above. It has arp main studs in it. rotating assembly spins freely. It has a 4 thousandths shorter timing chain due to bore and hone of machine caps. It also has a ductile roller 212/212 from full throttle with 885 roller lifters, but I might keep those for the stock motor I just got for the car. That is why I am considering selling this short block. It was assembled by the previous owner who past away. I have an idea of what the parts and machine work cost, but not sure of what to sale it for. I am kinda thinking of a price of 3000.00 but I am open to any reasonable offer. I'll get pics up tomorrow
thanks in advance,
Chance
thanks in advance,
Chance