Search results

I have a few TTA and 3rd gen parts parts listed on fleabay this week. View sellers item for more. Have more to list this week http://www.ebay.com/itm/380494226658?ssPageName=STRK:MESELX:IT&_trksid=p3984.m1558.l2649

Does anybody have an extra red msd plug wire in good condition?I was changing plugs and the metal connector inside the plug end broke in half..Thanks..LMK a $ to 21619 in MD.

I parked the car a few months ago and have not driven it since(I know,I know :mad:) I went out to move it yesterday and it wont start. Cranks over fine has FP but no spark. I swapped out the coilpack with a known good one..still no spark.. Where should I start looking next? I dont want to just...

36 mm hollow sway bar from a WS6 Trans am. Its in good used condition with the frame mounts included..$70 shipped. Paypal accepted

I have some very nice interior trim from a hardtop car.Visors,sail panals,and headliner were recovered.door sills,carpet,seatbelts,plastics.LMK efbsupply@netzero.com

I got my PHS packet today # 1176.It only took me a few years to get around to ordering it.:biggrin:

I have a new trans and converter I just put in tha TA,the problem is it shifts ok until it gets to OD.It wont shift into OD.I tried adjusting the cable in and out.I also unplugged the switch and nothing.Any suggestions? Also when I manually shift into 2nd and 3rd it bogs and feels like no...

FINALLY!!Its been down sice Nov when the trans went out.Which then turned into a trans rebuild,motor mounts,welding cracked header,plugs,wires,coilpack,rear main/oil pan gasket replacement,rear end service,trans cooler,new o2 sensor,interior color change,fiberglass rear spoiler.Its almost...

Does anyone know the NAPA PN# for the motor mounts.The search is down, I guess and I looked through the first 20 pages. Thanks

I was sitting at a light and all of a sudden the trans started to whine and make some funny noises.It didnt do it in Neutral,but as sood as I put it in gear it would do it again.I guess I am going to have to pull the pan and take a look. Any suggestions guys?

These are all @ idle #'s 02-085-734 18.8-20.4 AF 06 L8 38-41 bat 13.8 Int 126-133 BL 129 mph clt 157 ATS 46 R 800 tps 44 IAC 38 NAl 00 Then I have a couple things from the Snap on scanner: exhaust Oxygen - Lean/Rich going back and forth Airflow gm/sec - 6 Load/LV8 - 33 Spark...

These are all @ idle #'s 02-085-734 18.8-20.4 retard? AF 06 L8 38-41 bat 13.8 Int 126-133 BL 129 mph clt 157 ATS 46 R 800 tps 44 IAC 38 NAl 00 Then I have a couple things from the Snap on scanner: exhaust Oxygen - Lean/Rich going back and forth Airflow gm/sec - 6 Load/LV8 -...

The trans decides to give me trouble last night.When cruising it dosent want to shift 1-2 till 3500 or so.When you are WOT it dosent want to shift till you let off of it.It dosent want to hold any power at all.Any suggestions?:mad:

I just got a used scanmaster,and I need to know which wires to hook it up to. Thanks for the help

I just got the Caspers kit.Do you guys have any tips/tricks that i should know?It looks straight forward,but didnt come with directions.

Can someone tell me what lb these are.The #'s on them are 01720AA and they have the green stripe at the top. Thanks

My ATR 21/2 DP hits the frame.Does anyone else have/heard of this problem?Could the motor mount be bad and letting the motor lean a little to much to one side? Thanks

I am a newbie here.I just FINALLY bought a TTA.These are the mods that are done to the car.I would just like to know if you guys think I am on the right path here. ATR SS catback,2 1/2 down pipe and crossover,ATR strip chip,LT1 MAF w/Translator,70mm T.B,33# inj,AFPR,Transgo shift kit,2400...