Search results

hi guys, im running the racetronics fuel pump and hotwire system, and the only 2 times i went out with my 86 gn and needed to use the lights the stock amp alts burnt up . anyone have an answere to what i should do or upgrade to from my 120 amper...

hi guys, having problem with iac reading does not go below 79 ive set tps ect .. by the book and just replaced it and reset ect... no difference. yes even took it for a ride . any ideas?? please help mike...

just dropped rebuilt motor in . im new at the tr stuff , i got a small idle stumble , my idle screw is almost all the way backed out? i found that when i tried to adjust iac reading that wont com down anymore than77 . can anyone help me or give me an idea?? after my first ride around the block i...

just rebuilt motor stock turbo and inj. few small upgrades cam power plate ect... i have a joe lub 95 octaine chip have a scanmaster and i was wondering if 43.5 pds fp sounds right??or should i call him?? also i want to run toluene for octane , anyone have ideas ?? one more thing , where should...

stupid questions , 1 how much boost can i run, stock turbo and inj . has poston 430 cam 340 fuel pump , 2800 stall , joe lub 94 octaine chip , is it around 18 pds??and does 42 psi fuel pressure sound right?? 2 are all 4 rims the same dimensions? thanks guys...

hi guys could anyone tell me how much if any play should be at the turbo shaft as in side to side ? i have some but not enough to make the prop hit the housing but no play in and out and the turbo is bone dry right now ben sitting for a while and i know that the oil is going help but...

can anyone help me and tell me what the gap is between the signal tab and the sensor?? also has anyone had experience with the poston 107t cam shaft on performance its a 430 430 lift and254 254 duration??with a 2800 stall thanks mike:confused:

does anyone know who would be the person to burn a chip for me ?? maybe around the pa or mass area?? thanks mike

someone please help, i have 2 chips , 1 that came installed in car and it says on it lrx - 4 kb9006 proz equivalent not sure what that is ? also i have a hp137tx pit bull ? does anyone have an idea on with one if any is better than...

just wondering if anyone has tried the airflow power plate from kirbin, and if so how was it? also i have a stock motor except for chip cam and stall and few other small mods and im putting a high volume oil pump in , does anyone have an idea what pressure spring to use ? and is should the fuel...

please help wheres the cheepest place to buy a scan tool for my 86 gn ? also im pretty much all stock as in turbo and inj what fuel pressure should i be at ?? thanks alot mike

please help im fustrated with trying to match the grey paint with the dash i bought the paint that was said to be the exact match from poston by sem anyone had this prob ??also i have an 86 gn motor is at the shop just putting postons stock compatable 107 cam in it with a 2800 stall . i already...

please help!! 86gn both pwr windows work from drivers master switch pass side switch all five wires are hot nothing changes even when you work the switch. been through switches and tried a motor any thoughts??? thanks mike:confused: