Search results

  1. comradburk

    Grey Shifter Handle

    I need a complete, grey, stock shifter handle. I can't buy a new one because they require using the inside parts from your previous handle and I don't have that anymore. PM me please.
  2. comradburk

    Black 86 T-Type; Texas Car

    This is hard, but I think it's time to sell my car as I'm heading off to college and won't have the time or a place to work on this for a few years... The car is a 190k mile 1986 Black Buick T-Type with Grey interior. Currently the car is inspected and registered in Texas. I've used...
  3. comradburk

    Need Vacuum Brake Help...Badly!

    I installed the vacuum brake system on my car today because my accumulator went bad so I figured now would be a good time to convert and solve all my brake issues...Yeah right... I went to bleed the brakes and the rear bleeder screw on my driver side snapped off! It just broke right in half...
  4. comradburk

    Vacuum Brake Check Vavle

    I was just wondering how to test the check valve that goes in line with the vacuum brake system...you just blow into it and in one direction it shouldn't blow out the other side right? Because if so it looks like I need to stop by autozone before I install these bad boys...it sure does let air...
  5. comradburk

    Not Pumping Oil!

    Alright, this is really strange...It came time for my oil change, so, I changed my oil just like normal...I used Pennzoil 20w-50 oil with an AC Delco PF-52 oil filter. I get everything finished and I start it back up and it sounds noisier than normal so I take off the valve cover and see that...
  6. comradburk

    Vacuum Ball

    While I was going through my engine and replacing some vacuum lines, I noticed, using the mity vac, that my vacuum ball was leaking. Anyways, I unhooked it's vacuum line so it wouldn't leak but I was wondering if I need to replace it or if it's okay to run without it. Everything that's vacuum...
  7. comradburk

    Header Question...

    Alright, I found out that my passenger side header and drivers side header are cracked...so, since my car is fairly stock (has all the basic mods though, mainly the stuff for the 11's on a budget recipe at gnttype) would I be best off with a set of stock headers that have been rewelded and...
  8. comradburk

    A Few Interior Pieces...

    I'm looking for the chrome strip that goes across the middle of the dash and a complete set of AC vents in good condition. I also need a set of the chrome trim bars that go on the doors and I can't seem to find them anywhere, so if anyone knows where to get them or has some in good condition...
  9. comradburk

    ahollowtub

    I bought some 009 injectors from ahollowtub and I will gladly do buisness with him again. Shipping was fast and everything came undamaged and in good condition. Thanks!
  10. comradburk

    WTB: Restalled D5 and stock posi

    I'm looking for a restalled D5 converter, around 2600-2800 rpm would be great. I'm also in the market for a posi unit (just the posi, not the whole rearend). I'd prefer a stock gn one, but if you have an eaton or something you wanna sell, shoot me an offer on that as well. Either post back...
  11. comradburk

    General Torque Converter Questions...

    I just had some questions about torque converters... I understand how they work, and that the stall speed is the speed at which the two parts (turbine and pump i believe) spin at almost exactly the same speed and the stator is just kinda spinning freely (right??), so why exactly does it help to...
  12. comradburk

    Air Conditioner Problem

    Because summer is quickly approaching, I figure it's time to fix my air conditioner. The problem is that when you switch the climate control thingy to A/C, it doesn't ever engage the upper vents, instead it blows out the bottom where the heater should... Anyways, what needs replacing or...
  13. comradburk

    Seat Belt Question

    My passenger side seat belt is behaving quite oddly. For some odd reason, it only likes to "suck itself up" when the passenger door is open, and even then it's kinda weak. It's wierd though...it won't stay tight whenever you close the door... What needs replacing and where's the best place...
  14. comradburk

    WTB Parking Light Bezel (chrome)

    Just like the title says...either one or two would be fine. pm me or shoot me an email at comradburk@gmail.com Thanks.
  15. comradburk

    Fuel Pressure Guage

    I got a new adjustable fuel pressure regulator and now need a fuel pressure guage to adjust it. It doesn't matter if it's a window mount or not, I just need something...
  16. comradburk

    12" brakes on T-Type

    Using the list of parts needed here ... I know it's not possible with the gn wheels. Can I do the upgrade with my stock aluminum T-type wheels or will there be machining involved. Thanks!
  17. comradburk

    Brakes Dying??

    I was at a stoplight the other night which was the first time I noticed this potential problem. I had the brake pedal depressed and I heard this small hummm sound (the pump I'm guessing). I could also slightly feel it in the brake pedal (like a small vibration). The noise only lasted like a...
  18. comradburk

    Coolant Leak...

    I know I have a coolant leak because I get a fair amount of white smoke coming out of the back of the car when I start it up and sometimes even when I'm driving around. The coolant tank goes down slowly too, I would probably have to refill it about every 2 months at its rate. Anyway's, I'm...
  19. comradburk

    Need Front Chrome Bumper and Headlight Bezels

    I need a good front chrome bumper with/without rubber guard strip. I also need a headlight bezel for each side (black), and side marker lights too. This is my daily driver car so I don't want to pay for NOS parts.
Top