Search results

who currently makes the best 3" down pipe and cutout? I need one with a V band flange for a 7175 turbo.

What's the option of using flow master mufflers on our GNS ? What are the better mufflers to use?

Anyone have a wiring diagram for the steadfast underhood lock & ignition kill switch ? The guy doing a frame off restoration cut all my wires under the hood and am trying to figure out how to wire it properly- there are about 5 wires in all.

Does anyone have a set of good rustfree rear quarter panels for sale-i m in need for both sides?

I wonder why no one has made a billet shifter handle that resembles the stock one and maybe uses the stock internals?

I'm curious to what sizes fit and what tires work well with them? Anyone buy 17" if so any pics?

Does anyone know if LS1 12" brake conversions will fit with the new aluminum GN 15" wheels?

I got to say Kudos to G Body Parts for getting the most beautiful GN wheels I ever saw made- these wheels are Killer! And if you order them in October this month shipping is free- best GN purchase I ever made! Thank you Brian!

Is there anyway of telling what octane you have according to what the % of E-85 is in the tank?

anyone make one of these, I would like something to compliment my auto meter GNX dash install rather than a digital one which would look out of place.

I need a exhaust turbine housing for a four bolt Turbonetics T76 BB turbo with a V band that will fit a 3.5" v flange downpipe. The current I think is for a. 3" v band- too small.

Will this flange correctly fit a turbo with a 3 5/8" flange?

Does any one have 6 of these that bolt the seatbelt to the floor? I

Does anyone know if two of these pumps will fit on a double hanger sending unit?

Has anyone had any problems with the new billet air cooled ceramic bearings as far as failures of the bearings? Looking to get a 7175 turbo precision with the air cooled center section.

Does anyone know of a good welding shop in NYC that I can get my SS TA headers welded?

What's the best wide band and easiest to hook up that will work with a Scanmaster and power logger ?

Any one know formula for figuring cubic inches? My motor is a 4.1 block bored .020" to 4.020", 3.625 " crank, 6.350" rods.

Has anyone on here use one of his AOD trans with electric transbrake - suppose to handle 900 hp?

Where is the eccentric washer located on the cam sensor and what is its purpose?