Recent content by indysand

  1. I

    TIAL wasta gates

    I think it's fine if they price match, but I'm not going to do their job for them. I own my own business, and it's my responsibility to know what my competitors charge, not my customers job to tell me.
  2. I

    TIAL wasta gates

    I dont pay more just to keep a vendor in business. Thats bad business on your part if you do. If someone else can sell at 20.00 less, why dont these vendors give the same deeal to the board members they want to buy from them? Whenever i need a part, I research prices. I weigh the facts, price...
  3. I

    quadturbo v8

    Also, dont use a full carb enclosure. Has been proven to be inferior to the bonnets available from Extreme Velocity or CSU.
  4. I

    Boost controller question

    Sure, they will work on any turbo car with a wastegate. I suggest doing more research on which ones work best before you drop thatkind of coin.
  5. I

    quadturbo v8

    For any questions about blow thru carb stuff, go to turbomustangs.com . There is a forum stricktly for the carb folks like me. As for your quad turbo setup, are you going to run each turbo off of 2 cylinders? or are you planning to send 4 cyl into 1 turbo, then into a second turbo(this is how...
  6. I

    Boost controller question

    I'll assume you are refering to the electronic boost controllers as seen on many import turbo cars. They get the boost signal and hold it until you hit the boost level you want, then open the wastegate. Basically just a solenoid setup. It helps build boost a bit quicker because the wastegate...
  7. I

    TIAL wasta gates

    You could use a pair of Tial 38mm and would have lots of room to grow. Check ebay for tial wastegate. Normally around 200.00 each.
  8. I

    Roll bar tech question

    Sounds cool. Got any pictures? Phil
  9. I

    Engine specs??

    Thats just what i was looking for. Thanks guys!! Phil
  10. I

    Engine specs??

    Noone can help out with this?
  11. I

    Roll bar tech question

    There really isnt a rule about tilting the bar, although tilting makes the bar weaker in a crash or rollover. Why do you need to tilt it? Phil
  12. I

    Rear tires both wearing on the inside??

    I took his meaning to be the edges of the tires toward the center of the vehicle. If it was the centers of the tires, or both inside and outside edges, I would agree- tire pressure. Phil
  13. I

    Engine specs??

    Where can I find(preferably online) the engine specs(bore, stroke, journal dia, etc) for the turbo 3.8 motor? Also, what is the hp limint of the factory block and crank, when comined with aftermarket rods and light pistons? Thanks all. Phil
  14. I

    Rear tires both wearing on the inside??

    Sounds like a bent housing to me. Unless someone modified it for a bit of cambe(kile NASCAR guys do) for handling. Phil
  15. I

    Ca. Speedway

    Hope they prep the track, it was WAAAYY slick last month. Phil
See more
Top