$1750 for the following done to my engine
I believe this is a pretty good rate. Correct me if not
Align hone
square deck
bore .020
magnaflux then clean block 2x
recondition rods,,, (before we found out we would buy new ones)
Magnaflux 2 cranks (before we decided to go stroker)
New cam bearings
New rod and main bearings
New push rods
Misc head hardware
Champion Heads stripped down, inspected and cleaned a few valves cleaned up, then reinstalled, milled for RA.
Internal balance rotating assembly and make clearance if necessary for stroker crank
Degree cam
Engine assembly, complete.
Stripped and painted block
re-worked billet caps to mate new block
Now granted the only parts they supplied are the bearings, and the freeze plugs, push rods. I supplied
Head Gaskets 250, but free to me
Misc Gaskets all through the engine 100
Rotating assy 1650
Roller cam, lifters, springs, 625
SFI flex 175
Neutral balance harmonic 289
New old stock timing cover and water pump 325
Arp head studs and misc arp hardware throughout 150
Roll master chain 150
$5200, completely new 109 stroker engine??? Sound about right?