tminer
Not quite normal
- Joined
- May 25, 2001
I'm upgrading fuel lines and using Sakudog's technique of putting a 180 at the inlet. I'm going with the Rx filter so there looks to be enough room. Having read a lot here lately I got the idea that it would be interesting to monitor pressure losses and by putting taps before filter and just past pump I could monitor loss due to feed line and loss thru filter. Plus I won't have to crawl around when it's time to replace filters. Although monitoring the loss thru filter may cause the frequency to increase.
So it this a bonehead move like yesterday when I was looking for my heat gun to loosen up the rubber hoses when I was pulling the tank? Lucky for me I couldn't find it because I almost had a Depends moment when gas dribbled out as I pulled them off the hard way!
So it this a bonehead move like yesterday when I was looking for my heat gun to loosen up the rubber hoses when I was pulling the tank? Lucky for me I couldn't find it because I almost had a Depends moment when gas dribbled out as I pulled them off the hard way!