Rebuilding my motor with a spun rod bearing...
1) What head gaskets should I use?
2) Can I use stock lifters, etc with a 204/214 cam?
3) Where should i purchase new rods, rings, etc. ?
4) ARP Head studs.. Billet Caps.. Poly motor mounts...Do I need these? If so which vendor?
My ultimate goal is 7's in the 1/8th. What else am I going to need in this build that I'm not thinking about?
1) What head gaskets should I use?
2) Can I use stock lifters, etc with a 204/214 cam?
3) Where should i purchase new rods, rings, etc. ?
4) ARP Head studs.. Billet Caps.. Poly motor mounts...Do I need these? If so which vendor?
My ultimate goal is 7's in the 1/8th. What else am I going to need in this build that I'm not thinking about?