Precision intercooler fix

[happy4444]

Hey fellas. Im redoing some areas on my car and i took my precision fmic out and the top aluminum plate is bowed up slightly. Was wondering if any of you have had this issue and what the fix was? Should i cut an end and reweld it or just leave it? It doesnt effect anything its just cosmetic. Pics are below but its worse in person. Thanks in advance

 

[cetme1]

Mine developed a couple of small cracks/pin holes. I roughed up the areas and applied a small amount of JB weld to seal it. Been working great for years. I couldn't locate anyone that would work on an intercooler in this area. You might try a local radiator shop . How did the bow get in it?

 

[happy4444]

not sure where the bow came from the bottoms fine and it doesnt look like it was tweaked at all. when you push it down it sits flush, so i might put some quick steel on a stick and try and hit a few areas up top then push it down? rather try that than cutting and rewelding for no major reason