S SAMBALLS1 Active Member Joined Apr 12, 2007 Apr 3, 2015 #1 Does anybody know the length the drive shaft needs to be for the t400 with a ford 9" application? Thanks sam
Does anybody know the length the drive shaft needs to be for the t400 with a ford 9" application? Thanks sam
M Mike E Mr. Badwrench Joined Oct 9, 2006 Apr 3, 2015 #2 It depends on what yoke you have on the rearend. I have a moser forged yoke and use a 52" c to c driveshaft. It's actually for sale if you are interested. I need a shorter one for my t56 and would prefer not to cut this one down.
It depends on what yoke you have on the rearend. I have a moser forged yoke and use a 52" c to c driveshaft. It's actually for sale if you are interested. I need a shorter one for my t56 and would prefer not to cut this one down.
M Mike E Mr. Badwrench Joined Oct 9, 2006 Apr 3, 2015 #4 Yes, Mark Williams 3.5" chromoly with solid 1350 joints. No trans yoke, but a spicer forged is enough for just about anything.
Yes, Mark Williams 3.5" chromoly with solid 1350 joints. No trans yoke, but a spicer forged is enough for just about anything.