Chips and Rotary switch questions

[_Brent_]

I'm trying to figure out what the dial switch does. My 87 T Type has a Scanmaster 2.0, BstC controller and Maxeffort CHIP. I have a question about the 16 position dial switch. I've searched on the internet but haven't been able to find any manuals or information about what the 16 switch settings do (rotary switch with positions from 0 thru F). Does anyone have a manual for the Maxeffort Chipset or possibly a diagram that shows what the switches do ? Also the chip says "TT 36# Bluetop, 16 POS Maxeffort 18/24"

 

[we4Mateo]

I have not used this chip but you may get more responses from those that have by posting this in the general forum. You are in the right place, but that seems to be where most people look, and I think this is a general enough question. Good luck with your search. Have you tried using the search bar above?

 

[Eric Stage I]

Any other numbers on the chip label?

 

[_Brent_]

I have not used this chip but you may get more responses from those that have by posting this in the general forum. You are in the right place, but that seems to be where most people look, and I think this is a general enough question. Good luck with your search. Have you tried using the search bar above?

No, no other information on the Chip. I have verified it was a TurboTweak so right now I'm corresponding with Eric at TurboTweak for more information.

 

[_Brent_]

I have not used this chip but you may get more responses from those that have by posting this in the general forum. You are in the right place, but that seems to be where most people look, and I think this is a general enough question. Good luck with your search. Have you tried using the search bar above?

I did try the search but no luck yet. I will keep on searching.