dalesteraz
Member
- Joined
- Sep 19, 2005
Hello all,My first post here though I have been taking advantage of the info on 200-4r's for many years..Thanks to everyone for the great info available here! My question: I'm in the process of rebuilding a KZF but have no endplay at center support, even with no selective washer on output shaft. Endplay was .002 on rear section, low/reverse oil feed hole lines up properly in the case, but after installing forward and direct cluthes/housing not enough play to seat snap ring on center support. I have rebuilt a few of these, but not often enough (obviously) to be an expert. Thanks for any advice!!