I had a nice solution, if you run the stock ic.
Not sure if I got a pic. No i dont. Well heres what I did prior to engine removal for rebuild.
I use a piece of sheet metal and laid it on top of my IC, used the exsisting screw holes to attach plate to IC. I then set botlle on ledge, and used the zip tie attaching it to the center of the fan set up. So the botlle was directly between the two fans, the ledge held 90% of the wieght, while the zip ties held it from falling. Hood would close fine, and much easier to fill. I may even have the piece of sheet metal here, id have to look. If i do, and you want it, let me know. Just pay the postage and I'll send it, If i have.
DAve