Search results

Hi Looking for some input with the attached data log. Once the trans goes into 4th a couple seconds later my tcc box gets checked on the power logger that its engaged, but I don't see the rpm drop after the initial drop once it goes into 4th. Was the tcc activated with the shift into 4th so...

Hi Can someone please have a look at the attached log, My mass air and o2 readings seam out to lunch. Just got done having new ported heads and springs installed with a matching turbotweek chip with 60# matching injectors and a factory mass air sensor, I swapped out the mass air with a spare...

Hi. I have a couple OE exhaust valves that have wear grove just st below where the keeper sits. Is this normal. I have a used set that has 4 out of the 6 with this grove. Is it OK to use these ?

Hi, I bought a set of stock heads that are being ported by a friend. I bought comp cams 981 springs and valve seals for the intake valves.. Do I need shims ?. Thanks

Hi Just installed an original Translator Plus on the car tonight. Not sure if I got the dip switches correct on the box. Car started up rough and not wanting to idle. I didn't install the est wire. Noticed my o2 sensor wasn't jumping around when it was before the install. Car is dead stock...

Hi I have the coil pack off the car with the module still attached. Can I ohm the coil with the module connected ? if you can, I'm getting 11.68,10.78 and 10.55 ohms. I'm getting a code 42 which is why I started this. Thanks

Hi I posted this same thread on another board but it's getting late and I'm looking for some input Car is stock unopened. stock turbo and intercooler original valve springs low kms, walboro 340 with hotwire kit pro torque 2800 stall k/n afpr and a factory chip, I do have a no name burned chip...

Can someone please tell me what kind of wire to use to fill my header crack, for a mig and tig. Also any tips on removing the Drivers side header would be great thanks Dale :)

I can't get on the site now! Is it Down again?

I just installed my 92 Thrasher chip and noticed on the scanmaster that the right side decimal was blinking the hole time I had the car driving (half hour) Does this chip stay in open loop all the time?, I also noticed that my 02 readings at idle were very sluggish 21-22-21 all the time but when...

Is my mass air crapped out on me. I was with my wife today in the car and floored it for a about 6 secounds. My AF went from 41-238-248-235 before I had to let off the gas and let my wife relax. I want to take it out tonight and get more frames on the scanmaster. My 02s will start at 800 and...

Here Go's When I make a pass on the streat (1000 feet) my millivolts will start around 800 and then go way down after 2nd gear to around 710-680. My knock will get up to 8.9 on scanmaster before I get nervous and let off. I just had my walbro 340 and hotwire installed. My fp is at 45(line off)...

I have a Red Armstrong 93 for blue top injectors. My question is I have stock injectors and I would like to run this chip, How much would it cost me to change this chip to stock injectors. Also is this a good chip? Thanks Dale

Can you please tell me where I can get a Hooker Cat back System for my 87 Grand National. I'm heading to Florida and will be taking I 75 down from Detroit. Thanks Dale

Ok what would be the best turbo to buy and from what vendor, to easily run mid 11s. I don't have the intercooler yet but will come after the turbo is in. Thanks Dale.

I just installed my Scanmaster today and was wondering if someone could help me decode all the data that was displayed. r=925-975 Tps=.44 running Tps=.42, 468 engine off IAC=00 CC=10-252 ?AL=00, I don't know what the first letter is...

Do you have personalized plates on your Turbo Buick?, and if so what do they say. Please list any other plates you have seen on Turbo Buicks only.:)

When is the big mucsle car show on in Detroit. I think it's starting on Feb 21-23 but not positive, any one know for sure.

I'm curious as to which vendor sells the best Feeder kit for the fuel pump and also who sell's the best volt booster. I'm looking to buy them very soon ?

:cool: :) On July 11-13 the N.MC.A and RPM Classifieds are putting together a huge event at the Grand Bend Motorplex in Canada. There are going to be 10 classes with 5 heads-up street car quick classes and 3 indexed street classes which are 10.00,11.00 and 12.00. I went last year and...