Scanmaster #s ???

[Dale G]

I just installed my Scanmaster today and was wondering if someone could help me decode all the data that was displayed.
r=925-975
Tps=.44 running
Tps=.42, 468 engine off
IAC=00
CC=10-252
?AL=00, I don't know what the first letter is?
O2's+ 179-832
AF=05-06
L8=31,32,33
bAT=13.6-13.7
INT=120-130
bL=150
MPH= 00 obvious
CLT=162-164
ATS=69

All these were recorded with the car running for about 8 minutes. This is the first time the car was started since Sept. How do you get to see if you have any troulble codes? Thanks.

 

[MeanBuicks]

The parameter you have labeled as '?AL' is the trouble code parameter. (It represents MAL.) Anyway, you don't have any. If you did, you could look up what they mean at www.gnttype.org.

Check your TPS reading with the engine off/key on at WOT. That will tell you if it's adjusted properly at full throttle.

Do a search for topics covering your BL (block learn) and INT (integrator). These are often discussed.

 

[Dale G]

IAC Count

Should my IAC count be at o?

 

[OKTurbo]

No....IAC should not be 0...plus your idle BLM's at 150 is too high.

What chip are you running?

See this link for "normal" numbers http://www.gnttype.org./maint/quickref.html

John