Search results

Hi, Looking for a good 8.5 rear end. I'm in the DFW area. John 817-721-5805

Hi, I have a complete Powermaster brake unit from my 87 Turbo-T. Everything worked fine when I converted to Vacuum Setup. $80.00 shipped Thanks, John

Hello, I have a few items for sale. BstC Controller with Casper Y-connector adapter and 1 boost solenoid. $170.00 shipped OGS propane system. Make offer or trade. 2 Vector 8.5 inch wheels. Have lugs and caps. Straight, have been bead blasted at one time. Was going to use with my...

Hi, I've got a set of 8.5 inch Vector wheels that I picked up a couple of years ago to use with slicks. They have been sand blasted at one time and are straight. Cars gone, don't need wheels now. Prefer local pick-up. Springtown area. West of Fort Worth. $200.00 Thanks, John

Hi, Looking you some info. I went to the GMparts Direct site looking for a 3 bar map sensor. GM# 16040749. They say its been replaced by part# 12223861. But that new part requires new style connector. Connector is over 30 dollars. Looking to hook up my T-link and need sensor. Thanks...

Hi, Looking you some info. I went to the GMparts Direct site looking for a 3 bar map sensor. GM# 16040749. They say its been replaced by part# 12223861. But that new part requires new style connector. Connector is over 30 dollars. Looking to hook up my T-link and need sensor...

Hi, Im looking for some input on how you guys have made a cold air intake system. I'm getting ready to install a LS1 Maf and translator. Right now I have a K&N filter on the stock MAF. I would like to move the Filter out of the engine compartment. Looking to save some money and make my own...

I need some help. I cant get my 87 TR to idle. I've looked at the usual culprits and Im stumped. Car has recently installed MSD 50's. Car ran fine for several weeks after new injector and chip combo. Car has very rough idle and stumble. At idle its running rich enough to throw code 44. Can't get...

Hi, Looking for suggestions. Came back from track and all was well with car. Parked in garage and it sat for 3 weeks during a cold snap. Left trunk open. Went to start and battery was dead. Must be trunk light drained battery. Jump started and pulled out of garage. Car now runs rough...

Hi, Thinking about stepping up to 50 lb injectors and was looking for input on who to get a good street chip and race chip from. Thanks, John

Hi, Can anyone tell me if the Thrasher 92 for 868's still uses the EGR functions. Ive read that many aftermarket chips dont. Thanks, John

Wanted to see if this happened to anyone else. My 87 TR is in garage ready to go to track only need to do is change to race chip. Changed chip using proper procedure, and when starting car check engine light blinks constantly and car runs like crap. Swap back chips, same problem. Change...

Thought I might share this experience with everyone. Went to adjust my accufab fpr before heading to the track. Noticed that after lowering the pressure a couple of pounds(43) baseline that the pressure dropped off to 34 and would no longer regulate up or down. I have a Marshall liquid filled...

Hi, I was thinking about getting some 28/9-15 M/T slicks for my 87 Turbo-T. Question- Will these fit ok with stock rims, and do you have to run tubes? Thanks, John

Hi, Just started taking my 87T to the track. I would like to get some air bags for the rear to help hook-up. Can anyone point me towards a good source for them. Thanks, John

Hi, Need some help. I am trying to figure out what kind of sensor I have on the intake of the 87T I just bought. I thought the idiot light sensor, and the fan temp controller both mounted going aft on either side of T/B. Those are fine. In the front water jacket, drivers side there is a...

Hi, I was wondering if anyone might know where the hangouts or cruising is going on in the DFW area for fast street cars. Been out of the scene for quite some time. Just got a 87 T and was wondering where I might cruise to now. Thanks

Hi, Just got an 87T. Engine has 120k on it and I am gearing up for a serious spring cleaning, and tune-up. I have seen people mention that the valve springs on these cars need replaced on high mileage engines. Feedback appreciated.

Hello everyone, Just bought a 87 T-Type and I am needing some info. One of the previous owners made the rear-end in this car a "lincoln locker". Welded the open diff up. Needless to say Im needing to fix this. I need to find a posi unit for this rear, and am looking for info different...