Search results

My digital dash is stuck on kilometers ,anyone repair these? Would not mind going to gauges, is that pretty straight forward conversion? Not sure which route to go, if I have to pull out dash anyways maybe good time to change...Of coarse there's the cost...:rolleyes:

I just took my car out of storage a few weeks ago where its been since 1998...When I put the car in storage I had just put on a few mods:te44 turbo,307 fuel pump,adj. regulator,36 lb injectors,atr headers,3" down pipe and exhaust (no cat),K&n filter and pitbull chip..First thing I did after...

Looking for a good shop to have some minor work done to my buick,any suggestions...Thanks...

what is the sensor between air filter and the mass airflow sensor.What happens if its not plugged in...Thank you.

i have 2 sets of headers for my combo?Stock or Atr, my combo is same as below except for 14" k&n filter..I heard that the atr are no help with my combo,if thats true Ill put my stockers back on while Im putting a fresh turbo on the car. Thanks.

I have vacuum brakes on my gn and it stops fair.Who makes a good four wheel disc conversion (including larger front rotors) so it will stop good?Thanks.

this is the situation..My 87 gn has been sitting since july 2000 with a bad te-44.I have bought a new te-44, oil pressure gauge,water temp and most importantly a scan tool.The rest of my combo is atr chip (1997 issue) 36lb injecters,14" knn,adj regulator,307 pump w/ hotwire,adj. wastegate,3"...

does the scan master give air/fuel ratio on do I need a monitor for that?Thank you

what is the best way to clean intercooler,I want to make sure I dont run any metal through new turbo.Any thing else before firing motor (besides an oil change)

destroked 3.8?porsche 914 transplant? can you destroke the 3.8 turbo motor to say a 3.0 and if so what kind of rpms would be possible?

pulling my engine out and was wondering how much do I need to remove off the top of the engine to safely pull... also I see theres an anchor on the front of the manifold to hook a chain too,where do hook to on the back of engine? any suggestions on west coast engine builders,Id like to have me...

Im looking to get a new chip to replace my old atr chip.I have a te-44 and thinking about adding 50lb injectors.Whats the chip to get for my combo?The car is not a daily driver and will be used for fun only =).

I have a te-44 (approx 5000miles) that when inspected I found all the blades on the air intake side to be damaged and alot of shaft play.Most of the tips were missing on the blades and slightly bent back.When I called ATR (supplier) they stated something went through my turbo.I havent found any...

Has anyone installed a manual transmission in thier turbo regal?