Search results

Thanks for the contact. Appreciate it.

Looking for a good power master. Cleveland area thanks

Are the springs with airbags still available?

Those valve cover look nice. Wish I didn't just buy some.

I'll take it. Send PayPal info. Thanks.

Nope. Thanks.

Do you have pics of the rear Baer brake set up.

i also used total seal gapless rings i had a bad problem with smoke out of the exhaust i was told to put a vac pump on the valve cover and plug the other side it eliminated 95% of the smoke. i get a decent puff when in full boost for a extended period of time. no smoke under normal driving...

I understand the cam is big for my turbo. I rebuilt the engine knowing I was getting a different turbo. I ran out of money for a turbo. The car is a dog down low right now. Lol I have a 3300 stahll sitting in my garage waiting to rebuild tranny also this winter. What's a good injector turbo...

Heads are not pop yet pulling the motor again this winter. 42lb injectors. I didn't do anything with the crank except cut it 20 . Regret not buying a new one compression is at 8.6 :1 I have a 49 now at 18lbs. Just seeing what worked for other guys. I haven't read a lot on turbos yet I'm still...

I have a ta 49 turbo now. Im looking to get a bigger turbo. I have a good list of mods. I went with a 218/218 comp roller cam. I'm just wondering what is a good turbo for the money.

would the TPS being set to low card cause hesitation when you first take off

I got 95% of smoke to go away. I had a few hose leaks. That cleared up the white grey smoke. But I used total seal gapless rings. And I had a lot of smoke still coming out of the exhaust. I put a vac pump on and it got rid of 95% of smoke. Its not burning oil but I get a puff of smoke when I...

We are not sure if the gasket is bad.my guy is doing test on it I have a thick white grey smoke coming from exhaust. He did a pressure test on radiator. He didn't do a cylinder test yet. I'm hoping its the intake. My engine builder swears its not the head gaskets

Mistaken . sorry alot going through my head right now. Not sure if used a sealer on a head bolt that goes into a water journal. If he didn't would that cause water into cylinders

The heads were machined but not much taken off just cleaned. It idle a little ruff but not noticing a vacum leak. Water is in it since I have 10 miles on it since the rebuild. As far as the head bolts that go into the water jacket Im sure he used a lock tight. My Gn guy is looking at the intake...

Its not oil being burnt out of exhaust. Did a leak down test. And water is the problem. Its getting in there some way. My builder says there is no way it's the head gasket. I did have problems with the rubber on the front and back of intake used a lot of silicon. At first the intake didn't want...

I'm getting water in the cylinders and smoking out the exhaust real bad. Motor was just rebuilt used cometic three piece. When we put the intake on I don't think it seal right we had a hard time getting everything lined up since we put it on with the motor in the car already. My guy is...

Has anyone one had problems with there intake not sealing and getting water in the cylinders