Search results

Finally have the last trunk floor part to be welded in. Seems like some of my last post in this thread have gone missing. What's up with that?

I needed to get to the body mounts. The frame was in one piece but needed some attention at the mounting points. The body warranted complete mounting point replacement. I'm focusing on the frame while I wonder how I'm going to tackle the body.

Are panels available for this area? I've seen floor panels and trunk floor panels but have not seen anything for in between the rear wheelhouses. Is there a vendor you could put me onto or do I need to create something or salvage what i have?

My chime module had a mind of its own, work sometimes, not work, and barely audible sometimes. When I had a close look at the solder joints on the circuit board some were cracked. You need a magnifying glass to see this. I re-soldered the joints and it works great!

On the ignition module, pin F, gray red wire. Power feed to crank sensor. Question is this wire should have 12 volts on it right? KOEO this wire has no voltage. Running it has around 4-6 volts. Unplugging the sensor has no effect. The wires are sound between the two, the module is receiving...

Does anyone know the GM part number?

I know they existed, seen it in the service section in the back of the Buick manual. What do they look like?

How can two of my coils read "open" yet still be able to smoke a 5.0 Mustang? My car has low speed drivability issues but just loves it wide open.?? Posted from the TurboBuick.Com mobile app

I have seen the tape method, seems kind of crude. Does it work? And if so, what is the spec for the length? Posted from the TurboBuick.Com mobile app

The car used to do this, but since the engine was rebuilt and the trans had an inspection I found that the stator splines have worn to more than half their size. To make a long story short I left the trans as is. Now the vibration comes on at 50 and stays.....to the point of where you fear going...

My 1987 Limited has stock induction. What do I need to upgrade the MAF from factory? Posted from the TurboBuick.Com mobile app

Posted from the TurboBuick.Com mobile app I should know this and I can't find it anywhere.??

Anyone else have a child seat in the back of their Buick? My daughter always wants to go for a ride.

I hear a lot of guy say the stock coil packs go bad on TRs. Mine still has "April 1987" stamped on it. My question is what are the symptoms of a bad one, other than no spark?

I just have the basics, filter, air pipe, hotwire and 3 inch downpipe. I thought it was getting tired, maybe valve seals leaking so I had it rebuilt. Thought it could be leaking injectors so I had them checked and cleaned. I had the whole front clip off of it, cleaned and painted everything...

What's a good step up for a stock turbo? I have the 3 inch down pipe.