Search results

I'm trying to help out a friend with a TTA. He would like to replace the stock air box with a cone filter, can he just use a 9 inch k&n like the Buick's (does anyone make a cold air kit)? I would also like to eliminate the oil breather vent from entering the turbo. I know they make kits for the...

Wanted to replace the wastegate Y hoses. Does anybody know the vacume hose size I need to replace those worn out hoses with. Thanks in advance, Jon.

In need of a little help. I'm changing the chip on a '89 TTA and am not sure of the location of the ecm. Thanks in advance for your help, Jon.

200R4 Transmission from an 1986 GN. I purchased this trans. as a back-up for my car and have since sold it. Was told it worked when removed but planned on having it rebuilt. Asking $200 please call 412-596-0670 if interested, thanks Jon.

BOP Short tailshaft Turbo 400 with shift kit and deep GM pan, Driveshaft for 400 with spicer yoke and joints for G-Body. A direct swap usuing your 200 crossmember. Transmission works great, $400 please call 412-596-0670 if interested. Thanks Jon

I would like to sell my car to buy a full out race car. 1987 Gn with new paint last year. 64k miles, pa classic plated. Has run a best of 10.90 and 6.90 in the 8th, best mph 124. Craig Te-67 turbo Accufab I/C Translator and 3.5 mass air 62 mm jay jackson tb & upper Moroso underdrive...

I'm consudering purchasing a 1999 GS with a bad motor. Just curious if anyone has any long blocks for sale. If soo how much and where are they located. Thanks in advance, Jon.

Looking for front drag shocks. Thanks in advance, Jon.

Hello All, I've been considering purchasing a 3800 supercharged car. And was wondering why I neaver see any Riviera's at the Buick event's. Are they slower than the regals and pontiacs? If soo why, is it heavier or a different engine? Thanks in advance, Jon.

I've been collecting parts to built a bad TSM motor and have since changed my mind. Here's what I have: 109 Block hot-tank and magged Eagle Steel crank (New) BMS off-center rods (stock length with .927 floter pin) magged SFI internal flywheel (new) BMS internal dampner 20...

Hello, I'm looking for 72 or 83 lbs. injectors and chips as well as the modded ecm to run them. Also looking for dual in the tank pumps. Thanks in advance, Jon.

I'm freshining the bottom end of my motor, which is all stock and am looking for some advice. What type of timming chain should I use? Double roller or stock steel repacement with tensioner? I didn't really want to go with the TA billit since I''m not degreing the cam. Maybe an Edlelbrock or...

Looking for a stock 28 spline posi carrier for a friend. Please let me know what you have and how much. Thanks Jon