Recent content by SubZero350

Well, therein lies the problem. To buy these units from junk yards out-of-state (since I know of only about 3 or 4 within 1hr of here still left), I would be paying around $50-75 to buy then get it shipped here. If I offered a plug-and-play setup, it would only require the hooking up of a...

No prob, like I said: very involved and not for everyone...

Re: dash What do you mean? If you wanted to install it yourself? If that is the case, I posted some instructions on what is involved if you would like to tackle the project yourself: http://www.turbobuick.com/forums/showthread.php?s=&threadid=58151

They are availble here: http://netgearhead.com/

Hey I was wondering if anyone has tried out the HellFire torque converters for the 2004R yet and what kind of results you had with them...

Well, cost would be depending on what I can get the parts for plus labor to put them together. I was actually wondering what people would be willing to pay in a ballpark figure so I could determine if it would be worth my while to build these...

I was wondering how many Turbo Regal owners out there who would be interested in buying a converted park avenue digital cluster like the one I installed in my buddy's Turbo-T: http://dtcc.cz28.com/87turbot/parkave.htm What I would do is buy a few of these up from the junkyard as well as some...

Hey, found out that GM did use a virtually identical digital dash to the one I installed in 6-fitz's Turbo-T out of an 87 Park Avenue... Seems as tho one from an 87 Buick Skylark looks identical except for the fact it does not have the PRNDL gear selection indicator under the speedo. This...

I have not done rear disc on a G-body but you might look to the old '81 pontiac trans am turbo 301 V8 car for answers. these cars did have rear disc and I believe it was also an 8.5" rear so the backing plate flanges may be the same as the G-body 8.5! One thing tho, I seem to think that disc...

First of all, there is no relay under the coil pack. The only electronic device there is the ignition module. A faulty ignition module can cause a no-start, no fuel condition because the ignition module intercepts the hall-effect crank sensor signal and turns it into a pulse in which the ECM...

i posted some installation instructions here: http://www.turbobuick.com/forums/showthread.php?s=&threadid=58151

Well, you asked for it so here it goes (BEWARE, LONG POST) First, you will obviously need to locate a donar Park Avenue. Here is a list of things you will need from the Park Ave: -Instrument Cluster -PRNDL Module -PRNDL Sensor (optional -- any GM FWD OD will work if it has the 4-wire...

This car already had the digital atari display if that is what you were talking about.

Pics of the install now ONLINE! click here: http://dtcc.cz28.com/87turbot/parkave.htm

Got the installed pics ONLINE!!! click here: http://dtcc.cz28.com/87turbot/parkave.htm