I tried a search, but not finding much info. So, what are the noisy chains vs quiet ones vs the ones that aren't worth a crap? Is there a timing set available that uses a tensioner? Is a Cloyes ok...saw the Rollmaster but quite pricey for a timing set.
Thanks.
Hey Brian: Engine's at the Race Shop waiting for some back-ordered Probe pistons. What's this Texas address, not a GBGN anymore? I might have needed some parts from you!
Are the factory timing gears, chain, and tensioner still available? I tried to look up the parts using some part numbers I think were from GNTType org and got a "no match" on gmpartsdirect.
Thanks.
200-4R vs 200-C
I bought a G-force crossmember and plan to install a Rover/Buick aluminum V8 in the car eventually, unless my attention deficit kicks in (again.) I have the V8 parts except for a flexplate & an engine to trans adapter. What happens to the NA 3.8 and the 200-C? I have a few too...
Is the 200-C transmission the same length as the 200-4R? I am planning to swap a 200-4R into an 85 Regal that now has the 200-C and want to anticipate the need to swap or shorten the driveshaft.
Thanks in advance,
tp
Anyone who put in the biggie rear sway bar have a stock GN/TR one taking up space in your garage? I want one to put on the wife's NA 85 Regal. She loves the sofa-like ride, but when I drive it, the sway around corners is just too much! It borders on unsafe, and that's with a new set of shocks on...
I need a good, used, stock GN/TR balancer for my engine block that's at the machine shop. I prefer not to pull the one off the engine that's in my car now (it wouldn't be driveable if I did that!)
Thanks,
tp
I need to replace the wheel well chrome trim on the front & rear passenger side. Also in need of a chrome & blue hood ornament for an NA Regal that mounts on the header panel (all items going on a grandma fresh 1985 carbureted Regal that I just purchased for my wife. Car is in great shape, and...
I need a great looking 1986 TR burghundy 60/40 driver's side seat cloth (bottom and seat back.) Or better yet the material from an 86 burghundy rear seat (back and bottom.) I can have that cut and sewn to cover my worn out driver's seat. The 86 TR seat material seems to be different than the...
I need a great looking 1986 TR burghundy 60/40 driver's side seat cloth (bottom and seat back.) Or better yet the material from an 86 burghundy rear seat (back and bottom.) I can have that cut and sewn to cover my worn out driver's seat. The 86 TR seat material seems to be different than the...