just wondering what you figured out on this i want to run my 295 50 15 on a z28 wheel 15x7. they rub. they have a 4.25 back space and i need to order some spacers but im not sure how much i have to add to get these to clear.im thinking that 1 inch spacer would be enough but i dont want to have...
i also want to run a 295-50 15 tire but they hit the frame i have a 4.25 back space and need to order spacers did u get that measurement ? mine are on a 15x7 wheel will a 1 inch spacer work or should i just go with a 1/2 ?
you see i would just like to get the bottom end dead spot out of this carb. i know its not the best thing going but for right now its my ride to work .
the car runs good just has a dead spot when you go to take off. i cant afford any down time with it so right know tearing it apart is not an...
thanks for all your ambitions. all i want to do is get it running right with no bog of the start.
i do have a holly 500 2 bbrl that i could put on it but dont i have to also change out the dizzy and wire the lock up for the trans if i swap the carb ?
my car is a 84 regal 3.8 60 over 3 speed
i...
sorry guys i didn't mean to post in the wrong spot thanks for moving it for me.
see when the carb was tore down the solenoid screw was NOT counted witch was a mistake. and now i dont think the mixture needles have enough gas for a responsive take off.
i cant seem to find a factory starting point...
i have a 84 regal 3.8 carb. i am wondering if any of you wise people happen to know how many turn out the air screws should be on a e2me dualjet and also how about the air bleed screw and the mixture control solenoid where should they be. the rebuild instructions were not to clear on that one...