Recent content by boostedblkbeast

ttt

For sale 1986 Buick T-type - Project Car $3800 - 33511 This is a project car with a clean title. Whole car for sale not parting out. All parts included as follows: 1986 Buick T-Type Roller with 8.5 inch rear end Machined Block 0.30 over with front 3 steel mains TRW Forged Pistons with Rings...

I have not assembled the motor as of yet. It is still in pieces, but is ready to go otherwise. I know i screwed up and definetly will chalk it up to experience, i just figure at this point whats a few more bucks to make sure its right, but i thought i'd see what you guys had to say on it first...

I had my block fully machined and checked out good a few years back, including bored 30 over and align bore/hone done with the 3 forged mains to bolster the block up more. When I had it done, I did not have it done with the torque plates for any part of the machining. Since its been a few years...

Hi guys, I have my stock 200r4 out of my t-type that has 94k miles on it. I no longer need it since I switched to a turbo 400. I am looking to sell it to a friend who is in need of 200r4 to swap his blown tranny out. Just wondering what I should sell it to him for, I am not looking to give it...

2" drop spindles After reading about this set-up, it appears everyone that has done this has used the original spindles from a 99 blazer/s10 2wd, but does anyone know if the aftermarket 2" drop spindle will work. If so, are there any new clearance issues and do they in any way help out for...

ttt

I am freshining my motor, everything being redone and need to get new sensors. I am reusing my cam sensor, but with a new casper's cap, but as far as all of the others, should I go strictly GM or is their no difference with Napa /Advance sensors?

pics please send pics to jeff@tampa-allegra.com. thanks

With gas prices at an all time high, I thought possibly one of our great tuners could come up with a program similar to that of chrysler or gm that could shut cylinders down to improve gas mileage when at cruising speed. Whether by means of a chip, 8 position thumb wheel, or through the use of a...

email sent

The car is definetily going to see alot more street driving than track.

What is a good stock brake set up. I just want to upgrade the stock set up with better rotors, pads, braided lines, etc. And what about for the rear?

please send pics of trunk deck lid jeff@tampa-allegra.com

trunk deck lid Looking for a good condition trunk deck lid in black. Do you have pics you can get me? Do you accept paypal? Please email at jeff@tampa-allegra.com