TR Custom Parts
Mark Hueffman - Owner
- Joined
- May 25, 2001
Just messing around and did a little experiment with the 2 bar sensor taken off the GN when I went to a 3 bar for the alky kit. Thinking about running new lines for all the stock vacuum lines and didn't want to go the plastic hose route and compression fittings.
Cut the nub off the end of the MAP sensor and then cut down and drilled out an AN adapter for a snug fit over the MAP sensor. Seated in some JB Weld. Was a real snug fit over the MAP so wondering if this will hold up to boost? Will run the compressor to it to see what happens.
Cut the nub off the end of the MAP sensor and then cut down and drilled out an AN adapter for a snug fit over the MAP sensor. Seated in some JB Weld. Was a real snug fit over the MAP so wondering if this will hold up to boost? Will run the compressor to it to see what happens.