Wheel stud help

[RobG]

Guys,

I have a pair of C5 Corvette hubs that I need to replace the studs on, anyone here with a press that can help me out?

A pipe, hammer and a torch is not preferred

 

[nu2gn]

wheel hub,

send me pictures, i can probably help, i need to c what im working with.

 

[RobG]

It looks like this...

 

[nu2gn]

wheel studs

i have done many wheel studs, i have never had to use a press. looking at the picture( they are fronts) correct. all u have to do is remove caliper, bracket and rotor. you should have enough room in the back to knock the old studs. and when u install them,put them in through the back, buy wheel nut that has the open end, get a washer that fits around the bolt, screw the but in with an impact until it stops on the hub,really simple.

 

[slow87]

I got a small press, not sure if I got the plates you need.