what can yall tell me about this block

[hungerbuhler1]

i am gonna go with the 86/87 setup. just had already bought a used intake. so now i gotta find the top half for this motor, pulleys and all the other odds n ends...lot of work ahead of me. ive copied alot of pictures off of here for reference. hopefully it helps. the motor is bored .060 over. dont know if thats a good thing or a bad thing. all yall on here have been a big help as im just starting this project...just wanna say thanks. any other advice is truly appreciated

60 over?

 

[Habibacus]

too much???

 

[blackgn1]

I would have to say yes.

 

[TurboBob]

depends on if you are going to bore it again.

If the bores are reasonable, then you could hone it and reassemble it with new rings.

If you are not trying to set speed records, it would most likely be a good daily driver.

How do you know its .060?

Can we get some closeups of the pistons? Head ports?

Bob