Replacement fuel lines

[rarperformance]

What fuel lines do you use when building a 700hp motor? Do you keep the stock lines or go to a larger size? Do anyone know of a fuel line setup made for the Buicks that can be purchased? Thanks

 

[psycho6cyl]

You can keep the stock lines for the most part. Full throttle speed sells a line kit but you need a/n fittings on the pump side.

 

[TurboTnZ06]

Easy enough to make your own kit. Racetronix makes a kit I believe. Don Cruz sells racetronix as well. 813-399-0409

My system:
http://www.filoshare.com/garage/T/fuel/

 

[rarperformance]

Thanks!

 

[gunzandgearz]

Best thing to do is to build your own so you can route them where you want for best appearance.Just remember if your going to use AN fittings everything is measured in 1/16s of an inch, so a -6 would 6/16 or a 3/8 line,-8 would be 8/16 or 1/2 inch line.

 

[bison]

I've found that using the appropriate -8 line with the common 10 micron fuel filter canisters works better than just about anything. You can start at the back and work forward and route any way that best suits your needs. If the steel lines are going to be retained in the engine area you can weld the -8 male fitting to the steel line and the sender if needed. 8 sec power at full weight with -8 lines and the right pump(s) on gasoline only.


Sent from my iPhone using Tapatalk