I jacked the intercooler up, removed grille, and hooked tubes on intercooler, I can almost get it hooked up...BUT, where is it supposed to bolt in. Do I have to cut out a little of the hood release bracket? I think it is old style. The holes top to bottom measure the same, but side to side it is a little over 1 inch longer than braces in front of radiator. Any help is appreciated!!
Precision Fmic Install Help
- Thread starter 86BLACKT
- Start date
Rodney87GN
Well-Known Member
- Joined
- Feb 1, 2004
Not sure what the old style was like...but it sounds like you have the newer one like mine. You have to remove the 2 crossbraces in front of the radiator. The studded standoffs for the IC mount where the old crossbraces use to bolt to.
Also there's a tab thingy by the hood release bracket that I had to bend up out of the way. I'm assuming yours is hitting there too, but you don't need to cut anything.
Also there's a tab thingy by the hood release bracket that I had to bend up out of the way. I'm assuming yours is hitting there too, but you don't need to cut anything.
Rodney87GN
Well-Known Member
- Joined
- Feb 1, 2004
They don't....the top 2 holes are more inboard about an inch on each side than the bottom 2 holes.
