I have a GN that drove fine the last time I took it out. However, I tried
starting it after about a week and it starts up but bogs down and loads up
and backfires after a few seconds then idles at around 300 RPM no matter
what the throttle position is. I`ve disconnected the MAF to see if there was
a difference and there wasn`t any. It also wouldn`t display any codes no
matter what I unplugged. I checked the cam sensor, crank sensor, ecm
grounds. MAF and swapped chips and there is no change. The ignition
system is sound and all relatively newand the fuel pressure stays at around 44
psi It runs so poorly that I`m leaning towards a bad ecm. So I guess my main
question is if there is anyone in the Raleigh area that would happen to have a
good ecm that they would be willing to part with?
I can be reached at 919 616 4354 if there is anyone that can help me out. Thanks
starting it after about a week and it starts up but bogs down and loads up
and backfires after a few seconds then idles at around 300 RPM no matter
what the throttle position is. I`ve disconnected the MAF to see if there was
a difference and there wasn`t any. It also wouldn`t display any codes no
matter what I unplugged. I checked the cam sensor, crank sensor, ecm
grounds. MAF and swapped chips and there is no change. The ignition
system is sound and all relatively newand the fuel pressure stays at around 44
psi It runs so poorly that I`m leaning towards a bad ecm. So I guess my main
question is if there is anyone in the Raleigh area that would happen to have a
good ecm that they would be willing to part with?
I can be reached at 919 616 4354 if there is anyone that can help me out. Thanks