Got a few more things here to unload...
1) TA Performance dual valvesprings.
TAV1125AL springs
TAV1450A retainers
TAV1434B locks
Specs: 160lbs @ 1.830 installed height / 360lbs @ .550 lift.
Springs are 1.390 OD
VERY little run time on these... (maybe an hour or two total) couldn't make them work with my hyd roller and went to BBC beehives instead. These would be fine on a lower boost/less cam combo.
Complete setup, ready to install. $100 shipped
2) Alky pump (used/still good) This pump is a few years old. Still works, and good as a spare or home-built alky kit. $40 shipped
3) Strange TH400 slip yoke. Brand new never used. $60 shipped
4) 5" Autogage monster tach. It has no mounting hardware and is well used. Works fine but is no show-piece. $40 shipped
5) Pro Comp Ultralight Autometer tach. Again, not a show-piece, but works fine. It has a remote mount recall switch, but the button is missing.
Includes the mounting strap/hardware. $80 shipped
6) Stock crank and water pump pulleys. $50 shipped
7) Stock ECM / prepped for Powerlogger. $45 shipped
8) 12 pushrods - 8.400 long. $40 shipped
9) Pass side gray kick panel - hogged out for Powerlogger access. $30 shipped
PAYPAL is the preferred method of payment. PROMPT payment expected.
Email or PM with any questions...
yullose001@yahoo.com
PICS:
1) TA Performance dual valvesprings.
TAV1125AL springs
TAV1450A retainers
TAV1434B locks
Specs: 160lbs @ 1.830 installed height / 360lbs @ .550 lift.
Springs are 1.390 OD
VERY little run time on these... (maybe an hour or two total) couldn't make them work with my hyd roller and went to BBC beehives instead. These would be fine on a lower boost/less cam combo.
Complete setup, ready to install. $100 shipped
2) Alky pump (used/still good) This pump is a few years old. Still works, and good as a spare or home-built alky kit. $40 shipped
3) Strange TH400 slip yoke. Brand new never used. $60 shipped
4) 5" Autogage monster tach. It has no mounting hardware and is well used. Works fine but is no show-piece. $40 shipped
5) Pro Comp Ultralight Autometer tach. Again, not a show-piece, but works fine. It has a remote mount recall switch, but the button is missing.
Includes the mounting strap/hardware. $80 shipped
6) Stock crank and water pump pulleys. $50 shipped
7) Stock ECM / prepped for Powerlogger. $45 shipped
8) 12 pushrods - 8.400 long. $40 shipped
9) Pass side gray kick panel - hogged out for Powerlogger access. $30 shipped
PAYPAL is the preferred method of payment. PROMPT payment expected.
Email or PM with any questions...
yullose001@yahoo.com
PICS: