richy rich
Richy Rich
- Joined
- Apr 11, 2003
Ok-so last time out my 87 GN w these mods ran 11.94@112mph.
3660 w driver and fuel
TA49 turbo
36lb inj.
RJS power plate
Dutty neck[stock IC]
Some kind of hot wired bigger fuel pump.
K-N conical
Eric's TT race chip and c16.[turned up timing in low and second gear-02 and the rest very safe]
24 lbs boost-0 knock,left on 3lbs
255/60/15 Mickey DR's.
K so pretty much assume all rest is stock....
stock Torque converter
stock down pipe
car was corked up[cat out]ran through a Hooker system.
stock steel[read heavy]Steel GN Wheels-did I mention they were heavy!
yada yada
My question is-what are these next mods worth-anyone have an answer for just one mod at a time?
Torque converter lock up switch?
Switching to Weld Prostars[skinny's up front]-will keep radials[dr on rear] on all 4 corners.
aluminum driveshaft and rear brake drums
some kind of exh. dump or unbolting after the test pipe-if I can.but basically opening up exh.
I was real happy how it ran first time out[11.94-only bothered to make 2 pass's.]Just wanted to do some bench racing to see what my new mods may bring me.There's lots left in the tune as well-but thats an open book question.Just wanted some opionion's on the rest of my new mod's.
3660 w driver and fuel
TA49 turbo
36lb inj.
RJS power plate
Dutty neck[stock IC]
Some kind of hot wired bigger fuel pump.
K-N conical
Eric's TT race chip and c16.[turned up timing in low and second gear-02 and the rest very safe]
24 lbs boost-0 knock,left on 3lbs
255/60/15 Mickey DR's.
K so pretty much assume all rest is stock....
stock Torque converter
stock down pipe
car was corked up[cat out]ran through a Hooker system.
stock steel[read heavy]Steel GN Wheels-did I mention they were heavy!
yada yada
My question is-what are these next mods worth-anyone have an answer for just one mod at a time?
Torque converter lock up switch?
Switching to Weld Prostars[skinny's up front]-will keep radials[dr on rear] on all 4 corners.
aluminum driveshaft and rear brake drums
some kind of exh. dump or unbolting after the test pipe-if I can.but basically opening up exh.
I was real happy how it ran first time out[11.94-only bothered to make 2 pass's.]Just wanted to do some bench racing to see what my new mods may bring me.There's lots left in the tune as well-but thats an open book question.Just wanted some opionion's on the rest of my new mod's.