Getting out of Turbo Buicks (for now). All must go.

[beene006]

I would like the Walbro Pump for 35.00 is it 35 shipped? will that include all the equipment that goes with it? PM me. Robert Nashville, TN

 

[SinistrV6]

I would like the Walbro Pump for 35.00 is it 35 shipped? will that include all the equipment that goes with it? PM me. Robert Nashville, TN

Sorry, sold.

List has been updated guys. If it's not on the most recent list, it's gone. I'll update again later tonight 'cause more stuff has been sold.

 

[SinistrV6]

List has been updated again...


109 blocks (one standard but will need overbore)
(one .030 over)
$300 and $100 respectively

2 turbo cranks $125 each

Ported Stock Upper Plenum - $30

Spearco Intercooler (the kind they put in the hot-air conversion kits) - $100

3.5" MAF and MAF Translator - $150 Sale Pending

.020 JE Forged pistons w/Rings - $300

5 – stock Buick TR pistons and 2 dot rods - $75

Gauge pod - single A-Pillar $ 15

ECM - $75

ATR PITBULL chip for #52 injectors - $25

Casper's Electronics LC2 wiring harness for hybrid/race installations - $375

Ported stock intake - $250

TCI 2004R tranny - $400

12" 2800 stall convertor - $150

Crank Sensor - $20

Cam Sensor - $40

Stock up pipe - $15

Ported Stock DP elbow - $25

Stock DP - $15

Front engine cover - $25

Flex Plate - $20

Stock I/C fan - $20

Oil Pan - $35

Coilpack and ignition module - $100

Autometer Pro-Comp Ultra-lite gauges - $350 (will not part out at this time)

THESE ARE NEW IN THE BOX!!

3-3/8” Speedo
3-3/8” Tach
2-5/8” H20 Temp
2-5/8” Oil Pressure
2-5/8” Volt Meter
2-5/8” Fuel Level

Qboost in-car boost controller. NEW in original package with instructions - $40

1 set of A/C –alternator brackets - $35 set of 3 pcs

Driver's side header - welded - $40

Stock Heater lines - $25

2- Wastegate actuators - 1 is stock the other is modifed for adjustable boost - $15 each

Oil pump - $10

Stock oil dipstick and tube - $10

Balancer Pulley and water pump pulley - $20 - Sale Pending

Plugs, Plug wires and Oil filter (Plugs and filter are new) - $10

2 – double roller timing chain sets - $10 each

Turbo bracket (the one shaped like a question mark) - $40

2-3/4” I.D. Downpipe – mild steel. – see pics - FREE if you pay shipping

Fel-Pro gasket set #2700 - $15

Stock Hard vacuum lines - $15

DS intercooler bracket - $15

Link to pics in the previous posts.

 

[TinysTurboPerf]

Stock Heater lines - $25

Stock oil dipstick and tube - $10

Turbo bracket (the one shaped like a question mark) - $40

Will you sell all 3 of these for $75 shipped to Indiana 46221 Business address



.

 

[sawmillman]

got any pic of 9" K&N filter with polished MAF pipe (shine is NOT good) - $10 and how much to ship to 37772

 

[DailyDrifter]

what would be the price on the trans shipped to 18944? thanks

 

[that national]

are the cranks standard size? if so how much for shipping to 48446

 

[SinistrV6]

got any pic of 9" K&N filter with polished MAF pipe (shine is NOT good) - $10 and how much to ship to 37772

Already sold. Sorry.

 

[SinistrV6]

what would be the price on the trans shipped to 18944? thanks

DHL is usually about $120 for a transmission w/o convertor.

 

[91Bird305]

Cam sensor still available?

 

[melrob94]

pm sent

 

[SinistrV6]

Updated List

Pics of everything (I think) except the blocks and cranks are here--> click on the tach!




IF IT'S NOT ON THIS LIST IT'S SOLD!

109 blocks (one standard but will need overbore)
(one .030 over)
$300 and $100 respectively
2 turbo cranks $125 each

Ported Stock Upper Plenum - $30

Spearco Intercooler (the kind they put in the hot-air conversion kits) - $100

.020 JE Forged pistons w/Rings - $300

5 – stock Buick TR pistons and 2 dot rods - $75

Gauge pod - single A-Pillar $ 15

ATR PITBULL chip for #52 injectors - $25

Casper's Electronics LC2 wiring harness for hybrid/race installations - $375

Ported stock intake - $250

Crank Sensor - $20

Cam Sensor - $40

Stock up pipe - $15

Ported Stock DP elbow - $25

Stock DP - $15

Front engine cover - $25

Flex Plate - $20

Stock I/C fan - $20

Oil Pan - $35

Autometer Pro-Comp Ultra-lite gauges - $350 (will not part out at this time)

THESE ARE NEW IN THE BOX!!

3-3/8” Speedo
3-3/8” Tach
2-5/8” H20 Temp
2-5/8” Oil Pressure
2-5/8” Volt Meter
2-5/8” Fuel Level


Qboost in-car boost controller. NEW in original package with instructions - $40

1 sets of A/C –alternator brackets - $35 set

Driver's side header - welded - $40

Stock Heater lines - $25

2- Wastegate actuators - 1 is stock the other is modifed for adjustable boost - $15 each

Oil pump - $10

Balancer Pulley and water pump pulley - $20

2 – double roller timing chain sets - $10 each

2-3/4” I.D. Downpipe – mild steel. – see pics - free if you pay shipping

Fel-Pro gasket set #2700 - $15

Stock Hard vacuum lines - $15

DS intercooler bracket - $15
__________________

 

[SinistrV6]

Thank You, to all of you who've taken the time to leave feedback on your transactions with me. If you haven't yet done so, and are satisfied with our transaction, please do so when you have time.

I try to under-promise and over-deliver. If you're not happy with things, please contact me!

 

[SinistrV6]

Updated list

IF IT'S NOT ON THIS LIST IT'S SOLD!

109 block (.030 over) $100

1 turbo crank (.020/.020) $75

Ported Stock Upper Plenum - $30

Spearco Intercooler (the kind they put in the hot-air conversion kits) - $100

Gauge pod - single A-Pillar $ 15

ATR PITBULL chip for #52 injectors - $25

Casper's Electronics LC2 wiring harness for hybrid/race installations - $375

Ported stock intake - $250

Cam Sensor - $40

Stock up pipe - $15

Stock I/C fan - $20

Autometer Pro-Comp Ultra-lite gauges - $350 (will not part out at this time)

THESE ARE NEW IN THE BOX!!

3-3/8” Speedo
3-3/8” Tach
2-5/8” H20 Temp
2-5/8” Oil Pressure
2-5/8” Volt Meter
2-5/8” Fuel Level


Qboost in-car boost controller. NEW in original package with instructions - $40

Driver's side header - welded - $40

Stock Heater lines - $25

2- Wastegate actuators - 1 is stock the other is modifed for adjustable boost - $15 each

Balancer Pulley and water pump pulley - $20

2-3/4” I.D. Downpipe – mild steel. – see pics - free if you pay shipping

Stock Hard vacuum lines - $15

DS intercooler bracket - $15

 

[Mike70gtx]

I don't see it on the list anymore. Any chance you have the ignition module?

 

[SinistrV6]

I don't see it on the list anymore. Any chance you have the ignition module?

Sorry, don't have another one.

 

[rmar]

Hard vac lines please.

 

[toribio]

do you still have the filter with the maf pipe if you do i will take it let me know how much for shipping to florida 33321

 

[toribio]

if you still have the maf pipe with the filter ill take it how much for shipping to florida 33321

 

[SinistrV6]

if you still have the maf pipe with the filter ill take it how much for shipping to florida 33321

Long gone. Only what's in the updated list (see above) is still available.

Vacuum lines sold.