Am trying to install a converter onto the trans (200 4r) but it will not go on all the way.
Looks to be about 1" away from fully seating.
These 2 parts have been together before for a few thousand miles, but have been apart for a couple years during a engine refresh.
Have done lots of spinning, wiggling, swearing etc, & end up at the same distance in. Flexplate mounting pads are about 1/2" into the trans bell housing surface.
Have inspected the splines for burrs etc & found none.
Any ideas , tricks of the trade ?
Looks to be about 1" away from fully seating.
These 2 parts have been together before for a few thousand miles, but have been apart for a couple years during a engine refresh.
Have done lots of spinning, wiggling, swearing etc, & end up at the same distance in. Flexplate mounting pads are about 1/2" into the trans bell housing surface.
Have inspected the splines for burrs etc & found none.
Any ideas , tricks of the trade ?