I'm finally starting to work on the engine for my Skyhawk and I need to take care of a few details. One problem I've ran into is that the carburetor fuel filter/inlet interferes with the thermostat housing. Does anyone know where I can get a carburetor fitting for a 78 turbo 4v that doesn't have the internal filter? A threaded nut with a flare fitting would be great. I was planning on using an in-line filter anyway.
Oh, be careful beating on 30 year old engines. You never know what's lurking inside. Check out the half pressed wrist pin in the second picture. That wasn't even the cause of this "parts" engines demise.
Thanks,
Oh, be careful beating on 30 year old engines. You never know what's lurking inside. Check out the half pressed wrist pin in the second picture. That wasn't even the cause of this "parts" engines demise.
Thanks,