car died while driving crank only

[86wh1]

Took the Wh1 out for a cruise today was driving in town and car just died like someone turned key off... Will crank only have fuel pressure have spark WTF is it Crank posistion sensor or cam sensor issues no codes on scan master car has 42lb injectors walbro pump hot wire kit tubo tweak chip adjustable regulator its at 86 with 37k on the the car got any ideas i have a new crank sensor but i dont now if thats it........ paul

 

[johnny's86nash]

Similar post here earlier. start from the bottom up, crank sensor and wires, cam sensor and cap, check all the grounds (back of the motor goes to ecm) proper battery voltage, fuel pump wiring and grounds there. good luck trouble shooting

 

[whitecobra98]

oil pressure switch? happened to me

 

[chrisgarrett]

Cam sensor will not cause the car to quit. If you recently installed a crank sensor, that's where you should look first.

 

[chris_mile]

just went through this last week. car died like i turned the ignition off. had fuel pressure but the injectors werent dumping fuel and had no spark. crankcase sensor was damaged and i replaced it now its fine. look at the thread below hope it helps!



http://www.turbobuick.com/forums/general-turbo-buick-tech/261955-engine-stopped-running-need-help.html

 

[86wh1]

car is running agian thanks

turns out when i put the pump in i wired it backwards in the connector thanks for all your help from everyone Paul