There was some good info on here that I completely missed. I have bought the parts, but I haven't started the build yet. I'm still trying to decide on if I should run a 2.5" collector or a 3" collector. It would be nice to know the difference in spool time between the two. I don't think I would have more than a 90* bend on the end of the collector, so it would be a short distance.
I did buy 6266's. That may not get me to 1400rwhp, but it'll be a start. Precision's site rates them at 735HP a piece (bhp). There are numerous motors running Precision's ratings to the wheels and higher, however.
What power level do you guys think a 2.5" collector could support maximally?
I did buy 6266's. That may not get me to 1400rwhp, but it'll be a start. Precision's site rates them at 735HP a piece (bhp). There are numerous motors running Precision's ratings to the wheels and higher, however.
What power level do you guys think a 2.5" collector could support maximally?