4.1 block owners please step inside

[Sleeper]

Looking to see who has safely decked, or had to mill their 4.1 block, and by how much.

Please list your deck height.

Thanks

 

[regalracer1987]

i did mine .010 with no problems

 

[Sleeper]

Thanks
Keep em coming guys!

 

[Nasty Wendy]

I do not remember how much but mine was decked as well. The piston sat to low in the hole for my liking.

 

[fuzzyGN]

I have gone .025 for an N/A build on one but not sure on the new bullet. Most of the 4.1s I have had need several thou deck just to clean up. Maybe I have bad luck but .010 has been the MINIMUM I have gone.

 

[forzfed]

I do not remember how much but mine was decked as well. The piston sat to low in the hole for my liking.

Same here, mine was decked but I do not recall how much.

 

[Sleeper]

Thanks guys.

 

[Sleeper]

Sorry, it's been a while but now have the time to get back to my project again, so I'm resurrecting this thread.
Anyone else?

 

[ek02]

Mine was decked .030 on a N/A build to clean up some dings in the deck due to the block being stored in a machine shop for a long time. The head bolt threads had to be re-countersunk. So far, no problems with many runs on a 125 shot and 1200 street miles.

 

[earlbrown]

Mine was clean and squared after taking off .002"... then I took off another .033" to make it .010 shorter than a 109 block.

 

[Sleeper]

Thanks guys!